Tank Strip
- Typical application
- Door seals for silos and tanks to provide sealing for products such as sugar, flour, oils, chemicals and other media.
- Thickness
- Average thickness for punching is between 1/16”~1/14” (1.6mm~6.4mm) for most tank sealing applications. However, we can apply the same process to thinner and thicker varieties of rubber and other materials.
- Hole Shapes, Size, and Spacing
- GSS can manufacture virtually any hole pattern, and even supply oval, square, or alternate shaped holes. All rubber materials are available in slit-to-width rolls without any holes as well
- Available Materials
- Nitrile (Buna-N), EPDM, Silicone, Viton, Various non-rubber gasket sheeting materials available.
- Seal Length & Width
- Tank stripping is usually sold by uncut roll size, which varies By thickness and variety between 25 and 300 foot lengths. Naturally, we can cater to special requirements on roll length.
- Dimensional Tolerances
- Tolerances vary according to material and dimension specifications, but typically run around +/-.015 inches on Key dimensions like width and hole diameter.
